[Aug 2021] Leads4pass latest update Cisco CCDE 352-001 exam dumps contain PDF and VCE

The latest updated Cisco CCDE 352-001 exam dumps contain PDF and VCE.
All test questions have been corrected and updated to ensure 100% validity. You can practice the actual test questions in the Cisco 352-001 section online first.
For complete Cisco 352-001 exam questions and answers, please visit https://www.leads4pass.com/352-001.html (PDF + VCE) Cisco 352-001 exam “CCDE Written Exam”.

[352-001 PDF] Cisco 352-001 pdf free from leads4pass

Free share Cisco 352-001 exam PDF from Vcecert provided by leads4pass
https://www.vcecert.com/wp-content/uploads/2021/07/lead4pass-Cisco-CCDE-352-001-Exam-Dumps-Braindumps-PDF-VCE.pdf

[352-001 practice test Q1-Q15] Free sharing of Cisco CCDE 352-001 exam questions and answers from leads4pass

QUESTION 1
Refer to the exhibitCisco 352-001 exam questions q1

A service provider would like to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SPSW2. In which two of these ways can you design this solution? (Choose two.)
A. Enable Y.1731 Connectivity Fault Management on the SP switches.
B. E-LMI PDUs must be forwarded over VPLS.
C. Cisco Discovery Protocol PDUs must be forwarded over the VPLS.
D. Use upward maintenance endpoints on the SP switches.
E. Enable IEEE 802.1ag Connectivity Fault Management on the SP switches.
Correct Answer: DE

QUESTION 2
Which two conditions must be met for EIGRP to maintain an alternate loop-free path to a remote network? (Choose
two)
A. The Reported Distance from a successor is lower than the local Feasible Distance
B. The Reported Distance from a successor is higher than the local Feasible Distance
C. A feasible successor must be present
D. The feasible Distance from a successor is lower than the local Reported Distance
E. The feasibility condition do not need to be met
Correct Answer: AC

QUESTION 3
Refer to the exhibit.Cisco 352-001 exam questions q3

The network administrator of a large-scale EIGRP network has found that one hub- andspoke topology in the network is
incurring a lot of link flaps. While several attempts have been made to reduce the number of link flaps, it does not
appear
that the stability of the hub-and-spoke topology can be improved.
The reason for this is that most failures seem to result from power outages in a number of locations.
Which course of action should the network administrator follow?
A. switch routing protocols to OSPF, then create area boundaries to reduce the size of fault domains
B. summarize the routes advertised into the core of the network to reduce the impact of these frequent failures
C. demand that uninterruptible power supplies be installed at every point in the network to prevent future outages
D. switch routing protocols to IS-IS, which handles large neighbor counts better and supports Partial SPF by default
Correct Answer: B

QUESTION 4
An MPLS service provider is offering a standard EoMPLS-based VPLS service to Customer A, providing Layer 2
connectivity between a central site and approximately 100 remote sites. Customer A wants to use the VPLS network to
carry its internal multicast video feeds, which are sourced at the central site and consist of 20 groups at 5 Mb/s each.
Which service provider recommendation is the most scalable?
A. EoMPLS-based VPLS already carries multicast traffic in a scalable manner.
B. Replicate the multicast traffic on the P routers.
C. Replace VPLS with a Layer 3 MVPN solution to carry the streams between sites.
D. Use GRE tunnels to carry the streams between sites.
Correct Answer: C

QUESTION 5
What are two reasons to choose L2TPv3 over other technologies for a VPN solution? (Choose two.)
A. The VPN solution does not contain MPLS on the network core.
B. The VPN solution should support Frame Relay to Ethernet pseudowire connections.
C. The VPN solution requires multipoint Ethernet LAN service.
D. The VPN solution should be industry-standard.
Correct Answer: AD

QUESTION 6
Which IPv4 addressing and routing scheme can increase the availability of a network service during a DoS attack?
A. unicast
B. broadcast
C. anycast
D. multicast
Correct Answer: C

QUESTION 7
During a corporate merger, a network designer is asked for a solution that will provide connectivity between the two
enterprise networks. The solution must have the ability to support video sessions so that the CEO can message merger
activities to the employees. The designer decides to consider multicast as a transport with MSDP to provide
redundancy. Which transport feature does the network designer need to apply to the interconnecting firewall to ensure
that Source-Active messages between the MSDP peers can be sent in both enterprise networks?
A. unicast over a UDP connection
B. multicast over a UDP connection
C. unicast over a TCP connection
D. multicast over a TCP connection
Correct Answer: C

QUESTION 8
Refer to the exhibit.Cisco 352-001 exam questions q8

R2 and R3 are running EBGP and are learning Network A and Network B. R2 and R3 are also running IBGP to
exchange Network A and Network B. OSPF is IGP. R2 and R3 are advertising default routes. R1 and R4 can send and
receive
traffic from Network A and Network B respectively. However, Network A cannot send traffic to Network B.
How can you solve this problem?
A. create a tunnel between R2 and R3
B. create a tunnel between R2 and R4
C. create static default routes pointing from R1 and R4 to R2 and R3, respectively
D. convert R3 and R2 to ABRs so that R1 and R4 can choose the closest ABR to exit the network
Correct Answer: A

QUESTION 9
What information can you get from TCP flags while assessing an attack?
A. Type of attack
B. Target of the attack
C. Priority of the attack traffic
D. Source of the attack
Correct Answer: A

QUESTION 10
Which two mechanisms can provide fast Layer 2 down detection in Frame Relay networks? (Choose two.)
A. asynchronous LMI
B. millisecond LMI timers
C. A-bit signaling
D. Frame BFD Lite
E. section 9 LMI convergence
Correct Answer: AC

QUESTION 11
You are evaluating convergence characteristics of various interior gateway protocols for a new network design.
Which technology allows link-state routing protocols to calculate paths to destination prefixes that are functionally similar
to feasible successors in Enhanced Interior Gateway Routing Protocol?
A. Incremental Shortest Path First
B. Cisco Multiprotocol Label Switching Traffic Engineering Fast Reroute
C. Loop-Free Alternate Fast Reroute
D. partial route calculation
E. Fast-Flooding
Correct Answer: C

QUESTION 12
Which two design characteristics of Resilient Ethernet Protocol on a Metro Ethernet infrastructure are true? (Choose
two.)
A. Resilient Ethernet Protocol provides fast convergence on Layer 2 ring domains
B. Unidirectional Link Detection Protocol can be used in combination with Resilient Ethernet Protocol
C. Resilient Ethernet Protocol cannot load balance VLAN traffic across a ring
D. Resilient Ethernet and Spanning Tree Protocol can reside on the same switch and on the same port
E. Resilient Ethernet Protocol and Spanning Tree Protocol rings or domains can share a common link
Correct Answer: AB

QUESTION 13
What is the function of the Community String field defined in a trap PDU?
A. enable the routing of messages
B. allow authentication by management station
C. enable reliable delivery of messages
D. isolate the PDU within a defined region of the network
Correct Answer: B

QUESTION 14
A customer uses OSPF and BGP in their network. Which solution will continue forwarding packets during a temporary
failure of a P node?
A. Deploy MPLS TE
B. Enable BGP Flowspec
C. Enable NSF/GR for OSPF
D. Deploy IS-IS an IGP instead of OSPF
Correct Answer: A

QUESTION 15
You are designing an OSPF network with multiple areas of for a large client. Due to the size of the routing domain, all
areas except the backbone area are configured as stub areas. A new requirement is to connect a WAN link to a partner
organization with a static route to one of the stub areas, area 100. What should you do to redesign area 100, if anything,
in order to support this WAN link while minimizing the size of the link state database?
A. Convert area 100 into an NSSA.
B. Redistribute the static route as OSPF type E1.
C. Convert area 100 into a normal area.
D. No configuration changes to area 100 are needed.
Correct Answer: A


leads4pass updates Cisco 352-001 exam questions and answers throughout the year! All exam questions are updated and corrected in real-time by Cisco experts.
Guaranteed to be true and effective! leads4pass has the most complete exam policy! To pass the Cisco 352-001 exam 100%, please click https://www.leads4pass.com/352-001.html (Total Questions: 705 Q&A) leads4pass Cisco Braindumps is trustworthy! I wish you success!

[352-001 PDF] Get free Cisco 352-001 exam PDF online: https://www.vcecert.com/wp-content/uploads/2021/07/lead4pass-Cisco-CCDE-352-001-Exam-Dumps-Braindumps-PDF-VCE.pdf

exam

VCECERT is the largest community of Cisco free dumps, here has the latest and most complete Cisco (CCNA, CCNP, Channel Partner Program, Cisco Meraki Solutions Specialist, Express Specialization - SMB Track, Advanced Security Architecture Specialization...) dump Community.

Related Posts

Why Cisco Created 300-440 ENCC When AWS And Azure Already Dominate Cloud Certifications

AWS and Azure have largely won the battle for cloud platforms.

Why Cisco Created 300-440 ENCC When AWS And Azure Already Dominate Cloud Certifications

Yet Cisco continues investing in cloud connectivity certifications like 300-440 ENCC.

That decision reveals something important about how enterprise infrastructure is evolving.

The cloud market is no longer defined by who owns the most compute, storage, or platform services. The more interesting battle now revolves around how organizations connect users, branches, applications, SaaS platforms, security controls, and multiple cloud environments together. Cisco’s 300-440 ENCC certification exists because cloud adoption solved one problem while creating another: connectivity complexity. Cisco is not competing with AWS or Azure for cloud ownership. It is positioning itself around the infrastructure that connects everything surrounding the cloud.

🌐 The Cloud Adoption Problem Nobody Expected

The Emergence of the Connectivity Gap

When cloud computing first became mainstream, many executives assumed networking would become simpler. Move workloads into AWS or Azure, reduce dependence on data centers, and operational complexity should decline.

 » Read more about: Why Cisco Created 300-440 ENCC When AWS And Azure Already Dominate Cloud Certifications  »

ENCOR vs WLCOR in 2026: Which Cisco Certification Path Should You Choose?

Before writing this article, current Cisco certification updates and wireless certification changes were reviewed from Cisco’s official certification platform. As of 2026, Cisco has formally separated the wireless track from the traditional CCNP Enterprise path, introducing WLCOR (350-101) as the dedicated core exam for CCNP Wireless. Meanwhile, ENCOR (350-401) continues as the core requirement for CCNP Enterprise, focusing on enterprise infrastructure, automation, security, virtualization, and network assurance. Cisco’s 2026 updates also remove most wireless content from ENCOR, making the distinction between both paths much clearer than in previous years.

The Choice That Many Network Engineers Are Struggling With

A few years ago, the answer was relatively simple.

CCNA to ENCOR

If you wanted to advance beyond CCNA, you studied ENCOR. Wireless technologies existed inside the broader enterprise networking world, and most engineers naturally picked up WLAN skills while building routing and switching expertise.

 » Read more about: ENCOR vs WLCOR in 2026: Which Cisco Certification Path Should You Choose?  »